Ryobi HP512K - Manual (Page 12)

1
opeRAtIoN
BATTeRY
BATTeRY
PoRT
dePReSS lATCHeS To
ReleASe BATTeRY PACK
cHARGING A Hot BAtteRy pAck
When using the tool continuously, the batteries in the
battery pack will become hot. You should let a hot bat-
tery pack cool down for approximately 30 minutes before
attempting to recharge.
Note: This situation only occurs when continuous use of
the drill causes the batteries to become hot. It does not
occur under normal circumstances. Refer to
“cHARGING
tHe BAtteRy pAck” for normal recharging of batteries.
If the charging assembly does not charge the battery pack
under normal circumstances, return both the battery pack
and charging assembly to your nearest Ryobi Authorized
Service Center for electrical check.
to INstAll BAtteRy pAck
See Figure 3.

Place the direction of rotation selector in center
position.
 Place the battery pack in the drill. Align raised rib on bat-
tery pack with groove in drill’s battery port.
 Make sure the latches on each side of the battery pack
snap in place and that battery pack is secured in drill
before beginning operation.
to Remove BAtteRy pAck
 Place the direction of rotation selector in center po-
sition.
 Locate latches on side of battery pack and depress both
sides to release battery pack from the drill.
 Remove battery pack from the drill.
Fig. 3
lATCHeS