Rikaline GPS-6030 - Manual (Page 3)

SiRF Star IIe/LP Bluetooth GPS GPS-6030 Operating Manual
Rikaline
Rikaline International Corp. 10F, 64, Kang-Ding Road, Taipei 108, Taiwan
Tel: ++886 2 2370 4688 Fax: ++886 2 2370 4686 E-Mail: [email protected] Web: www.rikaline.com.tw
3
English Version
0. Quick Use & Basic Specification
After you have received your Rikaline GPS-6030 Bluetooth GPS Receiver, please do the following steps before
using the device.
0.1 Install the Battery in GPS-6030 and Fully charge for at least 7 hours
before using.
Low Power The right LED (LED 1) indicator turns RED (normally BLUE) when battery power
becomes low. Connect the receiver to a power source for continuous operation and
recharge the battery at the same time.
Charging The left LED (LED 2) indicator turns RED (or ORANGE) when the battery is being
charged. RED indicator switches off automatically when fully charged.
0.2 Power on GPS-6030
Press the power button on the topside for 0.5 seconds to turn on the receiver. The left LED (LED 2)
indicator will flash briefly, and the right LED (LED 1) indicator will start flashing.
0.3 Activate the Bluetooth function in your PDA or PC
Before activating Bluetooth function, please check your device is equipped with Bluetooth function. If not,
you may need to acquire an optional CF (PD-3005) or SD Bluetooth Card. Activate the Bluetooth card.
0.4 BT GPS Communication to PDA or PC
Waiting to connect The right LED (LED 1) indicator will flash if there is no communication between the
receiver and your device.
Connected The right LED (LED 1) indicator will turn to continuous lighting when the receiver is
connected through the wireless link with your device.
0.5 Turn off your GPS-6030
To turn off the receiver, press the power button on the topside for 3 seconds. The LED indicator will flash
briefly before switching off the receiver.
0.6 Appendix
0.6.1 Operation Time:
7 hours at continuous mode, longer time at power saving mode.
0.6.2 LED Indicator: GPS-6030 has two LED indicators.
The Bluetooth GPS has two LED lights which each has two colors. One is GPS & Charge status
LED and the other is Bluetooth & low power status LED. The Status table of LED shows as follows:
Status BT (Blue) Low Power (Red) GPS (Green) Charge (Red)
Low Power O O
Charged X
Battery Full X
No BT Connected X
Navigation Valid O(glitter)
Navigation Invalid O
BT RF Active O
<P.S.> O: LED active; X: LED inactive