RUSSELL HOBBS Washing Machine RH1042 - Manual (Page 7)

Water inlet connection
Only a qualified engineer should install this machine

Your machine has a single water (cold) inlet.

To prevent leakages on the connection joints, 1 seal is included in the hose
packing, (Fit this seal on the end of the water inlet hose at the tap side.)

Connect the bracketed end of the water inlet hose to the water inlet valve at the
rear of the machine and the other end to your tap.

Water pressure of 0,1-1 MPa from your tap will enable your machine to work more
efficiently, (0,1 MPa pressure means water flow of more than 8 litres in 1 minute
from a fully opened tap).

After all connections are completed, check for leakages around the connection
joints by turning on your tap completely and seeing if any water escapes.

Be sure that water inlet hose is not folded, broken or crushed.
 Mount the water inlet hose to a 3”/4 geared water tap.
Water discharge connection

Ensure that the water inlet hoses are not folded, twisted, crushed or elongated by
stretching.

The water drain hose should be mounted at a height of minimum 60 cm,
maximum 100 cm from the ground.

The end of the water drain hose can be fitted directly to the drainage hole.

Never attempt to extend the water drain hose by adding extra parts.
For Customer Services, Spare Parts & Manufacturer's Warranty Information please call 0845 208 8750
-8-