ResMed Positive AirwAy Pressure Device S8 Auto 25 - Manual (Page 10)

7 Using the S8 Auto 25
En
gli
sh
Starting Treatment
1
Make sure the power is on.
The product name is displayed briefly on the LCD screen, then the standby (Ramp)
screen appears. The key and LCD backlights also turn on.
2
Fit your mask as described in the mask user instructions.
!
WARNING
A mask should not be used unless your S8 Auto 25 is turned on and operating
properly.
3
Alter the ramp time if required.
4
To start therapy, simply breathe into the mask or press .
5
Lie down and arrange the air tubing so that it is free to move if you turn in your sleep.
6
After starting therapy, an introductory treatment screen will display:
Stopping Treatment
To stop treatment at any time, remove your mask and press . If your clinician
has enabled SmartStart/Stop, simply remove your mask and treatment will end.
Note: SmartStart/Stop does not operate if:
• you have a Full Face Mask; or
• Leak Alert is enabled.
Using the Mask-Fitting feature
The S8 Auto 25 includes a mask-fitting feature to help you fit your mask properly. The
mask-fitting feature delivers air pressure for a three-minute period, prior to starting
treatment, for checking and adjusting your mask fit to minimise leaks.
To use the mask-fitting feature:
1
Fit your mask as described in the mask user instructions.
2
Hold down for at least three seconds until air pressure delivery starts and
the following screen appears:
LK: 10L/min RR: 15
MV: 10.2 VT: 680
VA:SETL 4.0-10.0
A>>>> PS 6.0
S**TiMn TiMx 2.0
Ti 1.5s 1: 1.6
SpO2: 98%
HR : 60 exit This screen only displays if
ResLink and an oximeter are
connected
Inspiration information
Leak and breath information
Mode and pressure display VAuto
mode
example
Mask-fit star rating
MASK FIT:
excelnt
*****