RadioLAN 140 MOBILINK - Manual (Page 13)

890-013 06/02/99 Version 1 Page 8 © 1999 RadioLAN. All rights reserved.
Removing the MOBILINK Removing the MOBILINK
Always take care when removing the
MOBILINK from the slot. PCMCIA slots
are designed to tightly hold the card into
place. There are usually ejector buttons
on one end of the slot. Before
attempting to remove the card, follow
these important steps:
1. Press the ejector button. Pressing
the button causes the unit to
unplug from the internal connector,
and to partially slide out of the slot.
2. Once the card has moved slightly
outward, grasp the MOBILINK on
each side, at the hinge, and then
pull the card free from the slot.
3. Fold down the transmitter for
storage.
Figure 4: Ejecting the MOBILINK from the Slot