Maintenance – RedMax LRTZ2500 User Manual
Page 20
20
QUICK TIP
If the blades become so worn down that it is no
longer possible to eliminate the gap between them,
you should contact the authorized RedMax
servicing dealer from which you purchased your
RedMax® trimmer to have the blades resharpened
or replaced.
■ GEAR CASE
The reduction gears are lubricated by
multipurpose, lithium-based grease in the
gearcase.
Supply new grease every 25 hours of use or more
often depending on the job condition.
When adding lubricant, use a grease gun to insert
lubricant into the three grease nipples located on
the gear case. (MA2)
(1) Grease fitting
• Make sure that the engine has stopped and is
cool before performing any service to the
machine. Contact with moving cutting head
or hot muffler may result in a personal injury.
■ AIR FILTER
• The air filter, if clogged, will reduce the engine
performance. Check and clean the filter element
in warm, soapy water as required. Dry
completely before installing. If the element is
broken or shrunk, replace with a new one. (MA3)
(1) air filter
■ FUEL FILTER
• When the engine runs short of fuel supply, check
the fuel cap and the fuel filter for blockage.
(MA4)
(1) fuel filter
WARNING
9. Maintenance
(1)
MA4
(1)
MA3
MA2