RedMax HEZ2500S - Manual (Page 14)

❲ 14 ❳
SE4
■ MOUNTING ENGINE (SE1)
1. Push the driveshaft housing toward the clutch
housing and rotate it by hand to check that the
driveshaft is engaged with the gears.
2. Insert the driveshaft housing into the clutch
housing until it bottoms, and align the positioning
holes on the clutch housing and the shaft tube
and install the screw. When difficult to engage,
twist the engine slightly.
3. Fasten the clamp securely with two screws.
Tighten the screws gradually by turns.
■ CONNECTING THROTTLE WIRE
1. Remove the air cleaner cover.
2. Connect the end of the throttle wire to the joint
on the top of the carburetor. (SE2)
■ CONNECTING SWITCH WIRES
• Connect the switch wires between the engine
and the main unit. Pair the wires of the same
color.
■ MOUNTING OTHER PARTS
1. Insert the driveshaft into the clutch drum, then
attach the gearbox to the shaft tube as aligning
the positioning holes. Wipe out grease on the
tube and the inside of the gearbox. Screw in the
lock screw and fasten the clamp bolt firmly.
(SE3)
(1) Clamp bolt
(2) Lock screw
2.Install the blade guard to the gear case with the
provided 3 screws, then clamp it to the shaft
tube with 2 screws. (SE4)
IMPORTANT
6. Set up
SE1
SE2
SE3