Rosewill RC-304 - Manual (Page 5)

2 ports Parallel PCI card RC304 User Manual
6
Windows NT 4.0
Using the existing hard disk controller in your system, you need to install the ATA/100 driver into
Windows NT first. Without ATA/100 driver support, hard drive attached to the ATA/100 IDE controller
card can not boot up Windows NT.
Installing drivers with existing Windows NT 4.0:
Make sure Windows NT 4.0 is properly installed into your system first.
Step 1: Start Windows NT 4.0.
Step 2: Insert Driver CD into the CD-ROM drive.
Step 3: Select “Run” option in Windows NT.
Step 4: At the “Run” option, click on the “Browse” button.
Step 5: At the Browse for Folder window:
1. Select “CD-ROM Drive (D)”
2. Select NetMosMultiIODrivers.exe
3. Click on the Open button
Step 6: Finally, click the “OK” button
Step 7: Follow the instruction to finish the driver installation. Your system will automatically restart in
order to complete the driver installation.
Installing DOS Driver
Copy “D:\PCI_IO\NM97X5\DOS\NMDOSIN.EXE ” to your hard disk and run it.
Thank you for purchasing a quality Rosewill Product.
Please register your product at : www.rosewill.com/ for complete warranty information and future support for
your product.