Oregon Scientific Star Wars Darth Vader Laptop DV33 - Manual (Page 7)

3
Chapter 2 Chapter 2
Getting Started
The Darth Vader Laptop operates on 3 “AA” size
batteries or a 6V AC/DC adaptor (not included).
Battery Installation
1. Make sure the unit is turned off.
2. Open the battery cover at the back of the unit
using a coin or a straight blade screwdriver.
3. Insert 3 “AA” size batteries.(Note the correct
polarity: +, - ).
4. Replace the cover.
AC/DC Adaptor Connection
Please turn off the unit before plugging in the
AC/DC adaptor to prevent damage to the unit.
Plug the adaptor into the adaptor jack (center
positive type) located on the right hand side of
the unit. Plug the adaptor into a wall outlet.
Caution
• Do not mix different types of batteries or old and new
batteries together.
• Only use batteries of the same or equivalent type as
recommended.
• Remove all batteries when replacing.
• Remove batteries if the unit is not going to be used for
long periods of time.
• Do not dispose of batteries in fire.
• Do not recharge non-rechargeable batteries.
• Rechargeable batteries are to be removed from the toy
before being charged.
• Rechargeable batteries are only to be charged under adult
supervision.
• Remove exhausted batteries from the toy.
• Do not short-circuit the supply terminals.
Caution
• The unit must not be connected to a power supply greater
than 6V.
• Only use the recommended adaptor.
• The adaptor is not a toy.
• Do not short-circuit the supply terminals.
• Toys liable to be cleaned with liquid are to be
disconnected from the power source before cleaning.
• Due to AC/DC adaptor connection this product is not
suitable for children under 3 years to use without adult
supervision.
• Any safety isolating adaptor to be used with the toy
should be regularly examined for potential hazard, such
as damage to the cable or cord, plug, or enclosure of other
parts. In the event of such damage, the toy must not be
used until the damage has been properly removed.