Optiview 4CHs - Manual (Page 21)

4CH STANDALONE DVR
- 8 1 -
Foreword
This is a SATA convert PATA interface PCB board,
before using the product, please read this manual
carefully for further recognizing for the product!
I. Key Feature
Convert SATA TO PATA interface
Transfer rate max up to 66/100/133MB/sec
No SATA HDD capacity limited
LED indicators for Power(green) & HDD(red)
Compact JBOD ( Big ) special function.
II. Hardware and Install
III. Jumper setting for Master & Slave
1. One PATA cable with one SATA HDD then Jumper
setting in Master ( Jumper off )
2. One PATA cable with two SATA HDD then Jumper
setting in one is Master ( Jumper off ); and another is
Slave ( Jumper on ).
3. Using JBOD ( Big ) special function.
a.) One PATA cable with two SATA HDD then Jumper
setting same as step 2.
b.) Two PATA cable, each cable with one SATA HDD
then these two Jumpers always setting in Master
( Jumper off )
To Master SATA HDD
Jumper off
To Slave SATA HDD
Jumper on
4pin power cable
4pin power cable
40pin PATA connector
Jumper select
22pin SATA connector
4pin power
connector
Power LED
HDD LED
80pin PATA cable
4pin power cable
SATA HDD
Master SATA HDD
Slave SATA HDD
Device 0=Master (Jumper off)
Device 1=Slave (Jumper on)
11、SATA TO PATA CONVERT BOARD
(Option)