Ohlins FG 012 - Manual (Page 12)

12
Notes 19
Fasten the fork leg, at the fork bottom,
with soft jaws in a vice.
Install the compression valve as-
sembly in the fork bottom.
Tightening torque 65 Nm.
Apply some front fork oil on the
outer surface of the inner leg, and
push the outer leg up and down a
few times.
Measure the correct amount of oil
according to the specification card.
First, fill up the cartridge tube, then
raise up the outer leg about 250 mm
and add the remaining oil.
21
Install the fork top cap and the lock nut.
Tighten the top cap and the lock nut
against each other, use a 16 and 24
mm wrench.
Fit the fork legs on the motorcycle.
For tightening torques, please see
your bike's work shop manual.
Adjust the compression- and the
rebound valves according to the
specification card.
20
Install the damper rod assembly into
the cartridge tube.
Use Lotite 542 on the cartridge top lid.
Tighten with tool 1797-01.
Tightening torque 65 Nm.
Pump the damper rod up and down
a few times to check that there is no
air left.
Pull out the damper rod as far as
possible and close the compression-
and the rebound valves.
Install the spring and the preload
spacer.
19
20
21