Oricom TP30 - Manual (Page 10)

8
Basic settings
Basic settings
1. After installing the batteries, the display should flash the word
ENGLISH.
If not press and hold for approximately 4 seconds.
2. Select the desired language using or . Press DELETE/OK button.

4FMFDU
UIF
EFTJSFE
DPOUSBTU
TFUUJOH
 %FGBVMU

VTJOH
or .
Press DELETE/OK button.
4. Set the month using or . Press DELETE/OK button.
5. Set the day using or . Press DELETE/OK button.
6. Set the hour (00-23) using or . Press DELETE/OK button.
7. Set the minute using or . Press DELETE/OK button.
Display(LCD)Contrast/Time Setting
If you wish to change the language, contrast, time settings at a later date,
press and hold button for approximately 4 seconds and repeat steps 2-7
above.
Select country version
1. For New Zealand Select Recall = 600 on the switch on the rear side of
the unit, New Zealand Recall/flash time is 600ms, the unit is now set
VQ
UP
JOTFSU

XIFO
SFDFJWJOH
$*%
MPH
JO
BDDPSEBODF
XJUI
5FMFDPN

NZ requirements. Or for Australia Select Recall = 100.
2. Lift and replace the handset to initialize.
NOTE:
*G
UIF
TXJUDI
JT
JO
UIF
JODPSSFDU
QPTJUJPO
$BMMFS
*%
BOE
UIF
SFDBMM
GVODUJPO

will not operate correctly.