Outback Power Systems Hitch DOM-OBK03 - Manual (Page 13)

GPS IM
PLEMENT GUIDAN CE
®
11
18. Install CAN Cable: Install the remaining
Power/CAN connector (from either Step 14 or 15) into the
upper CAN port on the Hitch console as shown. Twist
connector firmly until it locks into place. For permanent
installations, we recommend removal of the cigarette
lighter plug and hard wiring the leads to a reliable 12-volt
power supply. The red wire goes to positive and the black
wire to negative.
Note: Cigarette lighter sockets are notorious for inter-
mittent power. For maximum portability, install a
female cigarette lighter receptacle wired directly to the
battery for each application. For permanent installa-
tion, we recommend wiring directly to the battery.
19. Install Hitch Control Cable: Install the Hitch control
cable connector (from Step 13) into the lower HITCH port
on the Hitch console as shown. Twist the connector firmly
until it locks into place.
20. Install Auxiliary Power Cable: Locate the auxiliary
power cable in the Hitch package. It has a connector on
one end and a pair of ring terminals on the other. Install
the cable connector into the upper right PWR IN port on
the Hitch console as shown. Twist the connector firmly
until it locks into place. Route the auxiliary power cable
directly to the tractor battery. The red wire goes to posi-
tive, and the black wire goes to negative.