Onkyo TX SR575 - Manual (Page 41)

41
Playing Your AV Components —Continued
The multichannel DVD input is for connecting a compo-
nent with a 7.1-channel analog audio output, such as a
DVD-Audio or SACD-capable DVD player, or an
MPEG decoder. See page 26 for hookup information.
Note:
• While the multichannel DVD input is selected, the
Speaker Configuration settings on page 56 are
ignored, and signals from the multichannel input are
fed to the speakers as they are.
You can display various information about the current
input source as follows.
The following information can typically be displayed:
*1 When AM or FM radio is used, the band, preset num-
ber, and frequency are displayed.
*2 If the input signal is analog, or AM or FM radio is
selected, no format information is displayed. If the
input signal is PCM, the sampling frequency is dis-
played. If the input signal is digital but not PCM, the
signal format is displayed. Information is displayed
for about 3 seconds, then the previous display reap-
pears.
Note:
• The listening mode is displayed only when speaker set
A is on.
Interpreting Surround Channel Information
A: The number of front channels (front left, front right,
and center).
B: The number of surround channels (surround left and
surround right). If there’s surround back channel
information, this number will be 3.
C: LFE channel for subwoofer (1 means yes).
Using the Multichannel DVD Input
Press the [RECEIVER] REMOTE
MODE button, followed by the
[MULTI CH] button.
The MULTI CH indicator appears on
the display.
Audio from the multichannel DVD
input will now be used for the DVD
input source.
RANDOM SUBTITLE
PLAY MODE
AUDIO REPEAT
RC- 681M
--/---
TAPE/AMP
M D/CDR
DOCK
CABLE
STANDBY/ON
DIMMER
ENT D TUN
SLEEP
10 11 12
INPUT SELECTOR
HDD DVD VCR
REMOTE MODE
V CR/DVR
AUX
CBL/SAT
C D TAPE TUNER
DVD MULTI CH
LISTENING MODE
T V
DISPLAY
TEST TONE CH SEL
SURROUND STEREO
CINE FLTR
LEVEL+ LEVEL-
L NIGHT
VOL VOL
SAT
VCR
T V
DVD RECEIVER
C D
+10 0 CLR
1 2 3
4 5 6
7 8 9
CH
DISC ALBUM
DISPLAY
RECEIVER
MULTI CH
RECEIVER
MULTI CH
MULTI CH indicator
Displaying Source Information
Press the [RECEIVER] REMOTE
MODE button, and then press the
[DISPLAY] button repeatedly to
cycle through the available infor-
mation.
DISPLAY
RECEIVER
Input source &
volume* 1
Signal format* 2
or sampling
frequency
Input source &
listening mode
A B C