Onkyo HT-R420 - Manual (Page 14)

14
Connecting the supplied FM and AM indoor antennas
Connecting antennas
Note
Insert one end of the AM antenna cord to either of the AM antenna connectors and the other end to the other connector. There is no difference
between one end of the AM antenna cord and the other end, unlike the speaker cables which have positive and negative poles.
Adjusting the position of the AM indoor antenna
The AM loop antenna is for indoor use only. Set it in the direction and position where you receive signals clearly. Put it as far away as
possible from the HT-R420, televisions, speaker cables, and power cords.
When reception is not satisfactory with the attached AM loop antenna alone, connection of an outdoor antenna is recommended.
AM indoor antenna
Insert into the
hole. Rotate the outer frame
of the antenna. Extend the
antenna cord.
Press and hold up
the lever. Insert the end of the
cord. Release the lever to
secure the connection.
REMOTE CONTROL
R L R L
IN IN IN IN
IN
COAXIAL OPTICAL
IN IN IN IN FRONT SURR CENTER
SUB WOOFER VIDEO 2 VIDEO 1
OUT
IN IN OUT
OUT OUT
DIGITAL INPUT
VIDEO 2 VIDEO 3 VIDEO 1 DVD MONITOR
OUT
VIDEO
S VIDEO
DVD
TAPE CD
FRONT SPEAKERS A FRONT SPEAKERS B
L
R
IN
VIDEO 3
R L
SURROUND SPEAKERS CENTER SPEAKER
L
R
AC OUTLET
ANTENNA FM 75 AM
SUBWOOFER PRE OUT
ANTENNA
Adjusting the position of the FM indoor antenna
The FM indoor antenna is for indoor use only. During use, extend the antenna and move it in various directions until the clearest signal is
received. Fix it with push pins or similar implements in the position that will cause the least amount of distortion.
If the reception is not very clear with the attached FM indoor antenna, the use of an outdoor antenna is recommended.
ANTENNA FM
75 AM
USA, Canada, Mexico
1 Strip away the insulation from
the end of the cord.
2 Fully insert the stripped end of
the cord.
ANTENNA
FM
75 AM
Australia
Insert the plug fully into the socket.
Other models
Insert the plug fully into the socket.