Vi) camera mounting description, Vii) camera usage – Oregon Scientific Action Cam ATC5K User Manual
Page 5
5
6
VI) Camera Mounting Description
The camera can be mounted in a number of ways using the straps and the velcro patch
provided. Please follow the methods of mounting as suggested below:
Fixing the position of the camera
a) With the base of the camera facing you, turn the clip
clockwise to tighten its position.
b) With the base of the camera facing you, turn the clip
counter clockwise to loosen its position.
Mounting the camera onto a helmet using the
silicon rubber strap:
1. Attach the rubberized patch to the bottom of the helmet mount grip.
2.+3. Thread the silicon rubber strap through the helmet grip.
4. Mount the helmet grip to the helmet using the silicon rubber strap.
5. Slide the camera into the helmet mount grip.
6. Adjust the angle of the camera making sure it's secure.
7. If the camera seems loose when the helmet is moved use the velcro patches to
secure it against the helmet.
8. To avoid damage to the camera, the mount lock at the base must be loosened
before twisting the camera.
Mounting the camera using the velcro strap:
1. Attach the rubber patch to the bottom of the helmet grip.
2+3. Place the helmet grip on the helmet, and thread the velcro strap through the helmet grip.
4. Secure the velcro strap by fastening
it through the helmet vents.
5. Slide the camera into the helmet
mount grip, and adjust the angle of
the camera making sure it is secure.
Note: Use caution
when twisting; the
clip may be sharp.
#1
#2
#3
#4
#5
#6
#1
#2
#3
#4
#5
Mounting the camera using the handlebar grip:
1. Place the handlebar grip on the handlebar.
2. Add the screw and nut to hold the handlebar
grip securely.
3. Slide the camera into the handlebar grip and
make sure the handlebar grip is locked
with the camera.
4. Adjust the angle of the camera.
Mounting the camera on a tripod or
camera mount:
1. Attach the tripod mount to the bottom of the
camera.
2. With the tripod mount on the camera, screw
it onto the webcam stand.
3. Adjust the angle of the camera.
#1
#2
#3
#4
VII) Camera Usage
Battery Installation
Use Caution, the edge of the base clip may be sharp.
When opening the cover make sure the clip is in
the same direction as the lens. Observe the following
precautions when opening the end of the camera:
1. Unlock the rear of the unit by squeezing the black
release buttons whilst lifting the latch.
2. Use a coin or screwdriver to turn the screw anti-
clockwise to release the battery door.
3. Insert 2 x AA alkaline batteries into the battery slot
with the polarity in the direction as shown.
4. Close the battery slot door and ensure the screw is tight
before closing and locking the latch.
Note: When the battery is low, the low battery icon will
appear on the LCD screen. Please ensure you save your
recording and then change the old batteries for new ones.
Always upload video footage to your PC prior to
replacing batteries to avoid memory loss
Note:
a) Do not mix old and new batteries together. Replace both batteries at the
same time.
b) Remove the batteries if the camera is not going to be used for extended
periods of time.
c) Do not mix alkaline, standard (carbon-zinc) or rechargeable
(nickel-cadmium) batteries. Only batteries of the same or equivalent
type as recommended are to be used together.
d) Do not touch the flat cable at the back of the camera.
(1)
(2)
(3)
ATC5K_manual-US0710.qxd 8/18/08 5:40 PM Page 5