Oregon SE300 - Manual (Page 22)

22
EN
NOTE You can reset all the targets at any time by pressing and
holding SET.
During the workout you can check the following information by
pressing SET:
• Target distance / time remaining and speed
• Target distance / time remaining and heart rate
• Clock and pace
• Total distance for all targets done and average speed
• Total time and average pace
NOTE The pace is the time (MM’SS”) required to finish one kilometer
or mile.
VIEWING TARGET DATA WHEN WORKOUT IS PAUSED OR
STOPPED
To view the memory for target performance:
1. Press ST / SP / + to pause or stop the target function.
2. Press LAP / MEM / - to enter memory mode. Odometer will be shown.
3. Press SET, “ALL” will flash. Then press ST / SP / + or LAP / MEM
/ - to select viewing overall memory or an individual memory.
4. Press SET to view each data.
For each individual target, the following data can be viewed:
• Time elapsed and average speed
• Distance traveled and average pace
• Average heart rate
For overall performance, the following data can be viewed:
• Total time elapsed and average speed
• Total distance traveled and best pace
• Average pace and average heart rate
NOTE Odometer is the total distance traveled after system reset.
It is shared with SPEED, TRAIN and CHRONO modes. To reset the
odometer press and hold SET.
SE300_M_EN_USA.indd 22 8/31/06 12:13:09 PM