Stereo analog audio to receiver – OPPO Digital OPPO DV-983H User Manual

Page 31

Advertising

I N S T A L L A T I O N

• Set

the

Audio Setup Page > Digital Output to “Raw”. This will ensure the original Dolby

Digital and DTS audio stream will be sent to the receiver for decoding. Stereo audio content will
also be sent in digital format.

-- Audio Setup Page --

HDMI Audio

Digital Outupt

LPCM Rate

EQ Type

Sound Field

Audio Tone

Pro Logic II

Dolby Digital Setup

Off

Raw

48K

None

Off

Due to bandwidth limitations of the technology and copyright restrictions, unfortunately it is impossible to send
high-resolution multi-channel digital audio from a source like SACD or DVD-Audio to the receiver using this
connection method. To enjoy SACD or DVD-Audio in their full resolution, please use the HDMI connection if
you have a receiver that handles HDMI audio and use multi-channel outputs if you do not.

Stereo Analog Audio to Receiver

If you primarily listen to stereo contents or your receiver only offers stereo audio connections, please use the
analog RCA-style cables to connect the FRONT/MIXED L/R output of the DVD player to your receiver, as
described in “Method 8” on page 16 of this guide. Depending on whether the receiver has surround speakers
and supports Dolby Pro Logic II decoding, you may use one of the following audio configurations:

• No Surround Speakers: If the audio system does not have surround speakers, please set the

Speaker Setup Page > Down-mix to “Stereo” or “V. Surround”.

-- Speaker Setup Page --

Down-mix

Front Speaker

Center Speaker

Surround Speaker

S. Back Speaker

Subwoofer

Channel Delay

Channel Trim

Stereo

Large

Small

Off

• Surround Speakers and Dolby Pro Logic II Support: If the audio system has surround

speakers and Dolby Pro Logic II Surround support, please set the Speaker Setup Page >
Down-mix to “Lt/Rt”.