Omega Vehicle Security LV132 - Manual (Page 2)

Sensor Pulled Through Interstitial Sensor Pulled Through Interstitial Sensor Pulled Through Interstitial Sensor Pulled Through Interstitial Sensor Pulled Through Interstitial
Space of Double-Wall Tank Space of Double-Wall Tank Space of Double-Wall Tank Space of Double-Wall Tank Space of Double-Wall Tank
Controller
LV132 Tip
SPECIFICATIONS SPECIFICATIONS SPECIFICATIONS SPECIFICATIONS SPECIFICATIONS
•••••
Input Voltage: 10-28 VDC
Current Consumption: Approximately 17mA
Output: TTL/CMOS Compatible
Output may sink 100mA up to 28 VDC
•••••
Not for use in freezing conditions (See Temperature Ranges)
•••••
Materials in contact with fluids are polysulfone, plastic, PVC,
stainless steel and polyolefin.
•••••
Repeatability: ±1mm
MAINTENANCE MAINTENANCE MAINTENANCE MAINTENANCE MAINTENANCE
Sensor may require a periodic cleaning of prism surface.
Chlorinated hydrocarbons must not be used for cleaning. Chlorinated hydrocarbons must not be used for cleaning. Chlorinated hydrocarbons must not be used for cleaning. Chlorinated hydrocarbons must not be used for cleaning. Chlorinated hydrocarbons must not be used for cleaning. A mild deter-
gent may be used to clean prism surface.
TEMPERATURE RANGES TEMPERATURE RANGES TEMPERATURE RANGES TEMPERATURE RANGES TEMPERATURE RANGES
PRESSURE RANGE PRESSURE RANGE PRESSURE RANGE PRESSURE RANGE PRESSURE RANGE
(° (° (° (° (° F F F F F )))))
0°F to 176°F
0 to 50 PSI, Max.
Conductivity Sensors
1/4" NPT
Optional
LV132 Tip
E lectro-Optic
Conductivity Sensor
Red: 10-28 VDC
Black: Ground
Green: Fuel/Oil
White: Conductive
Output
Label
(Electrical Rating)
1.10"
(27.94mm)
0.62"
(15.75mm)
3.22"
(81.79mm)
Cable (4) Conductor (PVC Jacket)
25 Ft to 25.5 ft Extended
(7.62 to 7.77m extended)
DIMENSIONS DIMENSIONS DIMENSIONS DIMENSIONS DIMENSIONS
(° (° (° (° (° C C C C C )))))
-17.8°C to 80°C
P/N 156837
INSTALLATION - Sensor INSTALLATION - Sensor INSTALLATION - Sensor INSTALLATION - Sensor INSTALLATION - Sensor
When installed in accordance with this installation proce-
dure, the sensor is suitable for use in Class I, Division 1,
Groups C and D.
1. With protective shield attached, sensor can be pulled
through interstitial space of double-wall tank. Sensor can
also be placed loose in tank or reservoir.
2. Sensor may be installed in horizontal or vertical
positions, only.
3. Do not install sensor close to infrared sources.
4. Prism surface must be at least 2" from any reflective
surfaces.
5. Connect 10-28 VDC power to red lead; return to
( ) black lead.