Installing the crossover – Orion HCCA 6.2 User Manual
Page 8
© 2007 directed electronics—all rights reserved
7
INSTALLING THE CROSSOVER
Step 1: Find a location for the crossover away from any factory or after
market electrical wires. It is recommended to mount the passive
crossover close to the amplifier. In the event you decide to upgrade
and bi-amplify the system, mounting the passive crossover close to the
amplifier would simplify the installation upgrade.
Step 2: Remove top cover of crossover housing. Don’t lose it.
Step 3: Mark with a marking pen the two mounting holes.
Step 4: Remove crossover and pre-drill mounting holes using a 1/8” drill bit.
WARNING:
Check for clearance of window mechanisms and electrical wires
BEFORE you drill.
Step 5: Mount the crossover using the supplied #8 screws.
Step 6: Connect the wires. Make sure the speaker wires for the mid/woofer go to the
woofer output and the tweeter to the tweeter output.
Be
sure
to
observe
the
correct
polarity.
Changing
the
polarity of the tweeter may be necessary for optimum sound quality.
Step 7: Re-install the crossover cover.