Onkyo TX-DS797 - Manual (Page 21)

21
When using the ZONE 2 OUT terminals
The ZONE 2 OUT terminal is a constant output. Connect to the
LINE input of the amplifier (CD, tape, etc.). Adjust the volume
with the amplifier connected to the ZONE 2 OUT terminal.
1. Connect the TX-DS797 to the amplifier for the
remote zone.
2. Connect the remote zone speaker cables to the
speaker terminals on the amplifier.
Adjust the volume level at the amplifier.
3. Connect the TX-DS797 to the monitor for the remote
zone.
Connecting the remote zone (Zone 2)
speakers
The TX-DS797 allows you to connect another set of speakers and
place them in a different room or separated area for listening to
music. This other room or area is referred to as the remote zone
(Zone 2), while the room where the TX-DS797 is located is the
main zone. In addition, the IR IN/OUT allows you to control the
TX-DS797 from the remote zone (Zone 2) with the remote
controller even though the remote zone is physically separated. The
diagram below shows how to make the proper connections for the
remote zone.
AUDIO VIDEO S VIDEO
MONITOR
OUT
R L
OUT ZONE 2
Remote Zone (Zone 2)
Main Room
Zone 2
Right speaker
Zone 2
Left speaker
Zone 2 amplifier
Left (white)
Right (red)
TX-DS797
Zone 2 monitor
or projector