Onkyo TX-NR708 - Manual (Page 57)

57
En
Auto Power Down
■
Auto Power Down
` Off:
Auto Power Down disabled.
` On:
Auto Power Down enabled.
The AV receiver will automatically perform STANDBY
operation when “Auto Power Down” is set to
“On” , with
no audio or video signal input, and if there is no operation
for 30 minutes.
“Auto Power Down” will display on the display and OSD
from 30 seconds before the Auto Power Down functions.
Default setting: On (European, Australian and Asian
models), Off (North American and Taiwan models)
Note
• Depending on some sources, the Auto Power Down function
may activate during playback.
• The Auto Power Down function does not work when Zone 2 is
on.
Network
See “Network Settings” ( ➔ 66).
Firmware Update
Note
• Perform the firmware update only when an announcement is
posted on the Onkyo web site. See the Onkyo web site for latest
information.
• It takes about 30 minutes to complete the firmware update.
■ Version
The current version of the firmware is displayed.
■ Receiver
` via NET:
You can update the firmware via Internet. Check the
network connection before update.
` via USB:
You can update the firmware from a USB mass stor-
age device.
You can update the AV receiver’s firmware. Do not shut-
down the power of the AV receiver while update.
■ Universal Port
`
via NET:
You can update the firmware via Internet. Check the
network connection before update.
` via USB:
You can update the firmware from a USB mass stor-
age device.
You can update the Onkyo dock’s firmware. Do not shut-
down the power of the AV receiver while update.
Note
• This update shall not be performed when no dock is connected
to UNIVERSAL PORT jack.
With this preference, you can protect your settings by
locking the setup menus.
Main menu Lock Setup
■
Setup
` Locked:
Setup menus locked.
` Unlocked:
Setup menus not locked.
When the setup menus are locked, you cannot change any
setting.
Lock Setup