Ethertalk – Oki C6100dn User Manual
Page 126
OkiLAN 8300e Network User’s Guide
Troubleshooting - 126
EtherTalk
Not identified by the Chooser and the Setup Utility.
Turn the printer off and on again.
Check the network cable is correctly connected.
Change the cable and try again.
If the network resides in a Zone, check the correct Zone name is
selected in the Chooser.
Check the Zone name in the utility related to the NIC is the same
as the Zone name set in NIC.
Check AppleTalk, which is displayed at the right bottom of the
Chooser, is set to Enable. (In some OS versions Network is used
instead of AppleTalk.)
Check Ethernet is selected in AppleTalk. (In some OS versions
Network is used instead of AppleTalk.)
Check the print driver is selected in the Chooser.
Check the EtherTalk protocol is set to Enable.
Print the NIC settings and confirm that the EtherTalk Port name is
not blank.