Oregon Scientific BPW120 - Manual (Page 11)

10
EN
No
power
Low
batteries
Display is dim
or will not
light up.
shows on
the display.
Batteries are
exhausted.
Batteries are
inserted
incorrectly.
Batteries are
low.
Replace with new
batteries ( P6).
Insert the
batteries correctly
( P6).
Replace with new
batteries ( P6).
shows on
the display.
1 shows
on the display.
4 shows
on the display.
5 shows
on the display.
A
measurement
error
occurred.
The wrist cuff
is not secure.
The monitor
detected
motion while
measuring
Pressure is
over
280mmHg
(37.3 kPa)
Relax for a
moment and then
measure again.
Refasten the cuff
and then measure
again ( P7).
Movement can
affect the
measurement.
Relax for a
moment and then
measure again.
Relax for a
moment and then
measure again.
NOTE
· The most recent record (1) is shown first. Each new
measurement is assigned to the first (1) record. All other
records are pushed back one digit (e.g., 2 becomes 3, and
so on), and the last record (30) is dropped from the list.
· Press MEM / UP again to see additional records.
· The date and time of measurement are shown with each
record.
· Memory records will be kept even when the batteries are
replaced.
TROUBLESHOOTING GUIDE
This section includes a list of error messages and frequently
asked questions for problems you may encounter with your
blood pressure monitor. If the product is not operating as you
think it should, check here before arranging for servicing.
Error
message
PROBLEM SYMPTOM CHECK THIS REMEDY
PROBLEM SYMPTOM CHECK THIS REMEDY
P/N: 086L003591-148 REV1
Page 11 of 122