Onkyo T-405TX - Manual (Page 15)

15
Befor
e Using
Connections
Other Information
Operation
4
Press the MEMORY button.
MEMORY
The clock will start operating.
Tip
Switching between the 24 hour and 12 hour
display settings:
1. Press the TIMER button repeatedly to
display “24H/12H.”
2. Press the ENTER button.
3. Use the UP π or DOWN † button to select
24H (24 hour display) or 12H (12 hour
display).
4. Press the ENTER button to confirm the
setting.
Note
• To use the number buttons instead of the UP π
or DOWN † button to set the desired day or
the week and time, select the 24-hour display.
If you select the 12-hour display, you cannot use
the number buttons to set the day and time.
• The ACCUCLOCK function is disabled if you set
the clock manually. If you wish to enable the
ACCUCLOCK function, refer to the following
section.
Clock Call function
You can execute the Clock Call function only by
using the remote controller that is supplied with
A-905TX amplifier.
1
Press the CLOCK button to display
the time, press again to cancel the
time display.
CLOCK
Note
If the time has not been set, “ADJUST” will
flash on the display.
Enabling the ACCUCLOCK
function
If you have set the clock manually (see page 14),
the ACCUCLOCK function is automatically
disabled. To enable this function, follow the steps
below:
1
Press the TIMER button repeatedly
until “ADJUST” is selected on the
display, then press the MEMORY
button.
TIMER
MEMORY
“MANUAL” appears on the display.
2
Press the PRESET √ or ® button
until “AUTO” appears, then press
the MEMORY button.
PRESET
MEMORY
“- -.- -” instead of the radio frequency will
appear on the display.
3
Press the MEMORY button.
ACCUCLOCK will become active whenever the
T-405TX enters STANDBY mode.