Oregon BPW128 - Manual (Page 12)

12
GB
AUTOMATIC POWER OFF
The device will automatically switch off after about 1 minute.
However, to conserve battery power, press the button when
finished to turn the unit off.
ERROR MESSAGES
Display
Err 1
Err 2, 8,
12, 13,
14, 15
Err 3
Err 4
Err 5,
6, 7
Err 9,
10,11
Description
Deflation period too long
Incorrect measurement
Cuff is not fastened
Vigorous motion is being
detected during
measurement
Measurement error
Calibration error
Remedies
Do not move during deflation.
Check whether the unit is worn
well on wrist and measure
again.
Check if battery power is low.
Change all batteries and
measure again.
Fasten the cuff and measure
again.
Stay calm and easy then
measure again.
Stay calm and easy then
measure again.
Retry again, return the unit to
the manufacturer for repairing
if same symptom persists.
( R e p a i r i n g / R e p l a c e m e n t
charge free only if under the
valid warranty. Proof of
purchase is needed).
Note:
1. Press and hold the [ ]button for 2 seconds, the display will flash
12h or 24h.
2. Press the [ ▲ ▲ ▲ ▲ ▲ ] button to select either 12 hour or 24 hour display.
3. Press the [ ] button to accept
4. The hour digits will flash. Press the [ ▲ ▲ ▲ ▲ ▲ ] button to set the hour
5. Press the [ ] button to accept
6. The minutes digits will flash. Press the [ ▲ ▲ ▲ ▲ ▲ ] button to set the
minutes
7. Press the [ ] button to accept
8. Similarly, set the display for year, day / month or month / day
setting, month and date.
9. Press the [ ] button to exit time date setting.