Olicom Broadband Wireless Router None - Manual (Page 5)

Important Notice
1. If you are using PPPoE, the default connection type is Dial On Demand and the Max
Idle Time is 10 min. You may adjust the max idle time as required.
2. As the default SSID for wireless connection is “IEEE 802.11 LAN”, it is recommended
to customize your SSID value.
3. To prevent your Broadband Wireless Router (AP) from being accessed by unauthorized
intruders, it is suggested to enable WEP encryption.
4. If a wireless client can not connect to the Broadband Wireless Router (AP), please
check:
a. Its SSID is identical to the SSID of your Broadband Wireless Router (AP).
b. Check if WEP is enabled and the WEP encryption setting is the same as the
Broadband Wireless Router (AP).
c. If your Broadband Wireless Router (AP) acts as DHCP server, check that the
wireless client resides in the same subnet with the Broadband Wireless Router
(AP). You may need to release and renew its IP address.
5. If your network cannot access the Internet, please check:
a. If connection from the client PC to the Broadband Wireless Router (AP) is OK.
b. Is the WAN connection type correct as required by your ISP?
c. If PPPoE is used, do you use correct Username and Password?
d. Check the connection to the xDSL/ATU-R.
5