Oce North America TCS400 User Manual
Page 19
Safety information (GB)
19
Connection
Attention:
Do not move the machine yourself, but contact your Customer
Service.
It is recommended to connect only those products which meet the (inter)na-
tional product safety and radio frequency interference standards, and to use
an attachment cable as specified by Océ.
■
If for some reason you have to move the machine yourself, please make sure
that the mains power point has the right fuse capacity. See the Océ TCS400
safety data sheet in this appendix for information about maximum current.
■
Do not bridge any mechanical or electrical circuit breakers.
■
Do not use an extension lead to connect the machine.
■
This machine is not designed for connection to an IT power system. An IT
power system is a voltage network in which the neutral wire is not
connected to earth.
■
When the machine is connected through a wall socket, place the machine
near a wall socket that is easily accessible.
■
When the machine is connected through a fixed connection to the electricity
grid, the disconnect device in the fixed connection must be easily
accessible.
Surroundings
■
Make sure that the machine is placed on a level, horizontal surface of
sufficient strength. See the Océ TCS400 safety data sheet in this appendix
for information about the weight of the equipment.
■
Make sure there is sufficient space around the machine. This facilitates
reloading materials as well as maintenance.
■
Do not place the machine in rooms which are subject to excessive vibration.
■
Do not place the machine in rooms which are too small or insufficiently
ventilated. See the Océ TCS400 safety data sheet in this appendix for
information about space and ventilation requirements.