Oricom IP-7 - Manual (Page 9)

Page 9 of 11
USING A HEADSET
It is possible to connect a headset to your IP7.
The headset must have a 2.5 mm, 3-pin phone jack.
Plug the phone jack in the socket on the right-hand side of the receiver
cradle. The headset can only be used for listening and talking while the plug
is connected in the socket.
Use the button on the keypad to adjust the receiver volume during a call. The
value set is automatically stored.
Note: If you have set the volume to low it is possible that a subsequent caller
can hardly be heard if they talk quietly. In such cases, increase the volume
again.
DEACTIVATING THE IP7
To listen to music via the computer’s internal or external speakers you will
need to deactivate the IP7 and reset the default computer settings. To do this,
unplug the IP7 from your computer, or to deactivate it manually please carry out
the following steps.
Deactivating under Windows XP / 2000
Note: The names of the menu items and buttons may vary slightly according
to the operating system being used, e.g.:
Sound and audio devices
= Multimedia . The steps for installation, however, are identical.
1. Open the Start menu.
2. Select Settings , Control Panel and then Sounds and Audio Devices .
3. Click on the Audio tab control.
4. Select the device to be used from the Default device pull down menu.
Complete this process for both the Sound playback as well as the Sound
recording .
5. Click on the OK button to apply the settings and exit from the pull down
menu.
To reactivate the USB phone simply plug it in and your PC will auto detect
and install the device.