One Step Ahead 97781 - Manual (Page 3)

Page 3 SKU 97781 For technical questions, please call 1-800-444-3353.
Maintain Appliance With Care - Keep 6.
cutting edge sharp and clean for best
performance and to reduce the risk of
injury.
Check for alignment of moving
7.
parts, binding of moving parts,
breakage of parts, mounting, and
any other condition that may affect its
operation. Any part that is damaged
should be properly repaired or
replaced by a qualified technician
unless indicated elsewhere in this
manual.
When servicing use only identical
8.
replacement parts.
Keep blade sharp.
9. Have it
sharpened by a professional when
grass is not being cut properly.
unPacKing
When unpacking, check to make sure
that the item is intact and undamaged. If
any parts are missing or broken, please
call Harbor Freight Tools at the number
shown on the cover of this manual as soon
as possible.
assembly and oPeRation
instRuctions
Read the entiRe imPoRtant
saFety instRuctions
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
note: For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
Gently push on each side of the Bar 1.
(23) and slide it onto the knobs on the
inside of the Shaft Holder (1).
Secure both Handle Shafts to the Bar
2.
using Nuts (22) and Bolts (21).
Attach the Handle (19) to the Handle
3.
Shafts using Nuts (22) and Bolts (21).
The Roller Adjustment Knobs (16)
4.
can be used to adjust the rollers up
or down, depending on the length of
grass desired for the lawn.
Before operating the Lawn mower,
5.
put on ANSI-approved safety goggles
and other safety gear. Safety
goggles and other safety gear are
sold separately.
Clean, then store the appliance
6.
indoors out of children’s reach.
maintenance and
seRVicing
Procedures not specifically
explained in this manual
must be performed only by a
qualified technician.
beFoRe each use, 1. inspect the
general condition of the Lawn mower.
Check for loose screws, misalignment
or binding of moving parts, cracked or
broken parts any other condition that
may affect its safe operation.
aFteR use,
2. clean external surfaces
of the appliance with clean cloth. To
minimize the chance of corrosion,
after each use, wipe blade edges with
a cloth soaked in lubricating oil before
storage.