Oki Pos 441 - Manual (Page 43)

–  –
n DIP switch
SW No. Function ON OFF
- Always ON Should be set on
- Auto Cutter * Invalid Valid
- Always ON Should be set on
-4 Command emulation Star ESC/POS
-5 USB mode * Printer class Vendor class
-6  colors printing Valid Invalid
- Reserved
- Print head model *  pin wire  pin wire
* The factory settings for enabling/disabling the auto cutter are as follows.
Models without auto cutter: Invalid (Switch - = on)
Models with auto cutter: Valid (Switch - = off)
Note: Do not enable the auto cutter for models without the auto cutter (i.e., models with a
tear bar). A mechanical error will occur.
* USB interface model only
* Do not change the default setting (Switch - = off).