Oricom CITIZEN BAND RADIO PMR1200 - Manual (Page 10)

10
Getting Started
Battery meter
The battery meter is located in the left corner of the LCD screen.
It appears like a battery with three bars inside. These indicate
the amount of power available. When the battery level reaches it
minimum level, the unit will emit two beep tones and automatically
it will power off.
Your PMR1200 can detect the battery charge in 4 levels;
Battery charge at high level.
Battery charge at medium level.
Battery charge at low level. At this level, the radio will emit
a “beep” sound for every 10 seconds in standby mode.
TIP: At this stage, you need to recharge the unit at
once, otherwise the battery will run down totally.
Battery charge at very low level. When the battery level
reaches its minimum level, the unit will emit two beep tones
and automatically turn off the power.
Important: You need to charge the unit for 10-14 hours.
CAUTION: Risk of explosion if battery is replaced by
an incorrect type. Dispose of used batteries
according to the instructions.
f. Charging the battery pack (using adaptor)
Lift the charge socket cover located on
the right side of the handset.
Insert the round connector of the 9.0V
DC/200mA adaptor into the charge jack.
Plug the mains adaptor into a 240V AC,
50Hz main socket with the switch on the
socket set to OFF.
Then switch ON the main socket.
Mic/spk jack
Charge jack