Onkyo SKS-HT870 - Manual (Page 8)

En-
8
Getting to know Your Speaker Package
—Continued
Before you connect the speakers, attach the supplied
speaker base to each SKF-770.
1. Turn the speaker upside down with the protection
cover attached.
2. Align the speaker base while the arrow mark is
headed in the same direction as the speaker’s face.
Be careful not to tip over the speaker.
3. Align the screw holes on the speaker base with
those on the bottom of each speaker, and affix the
speaker base using the supplied screws.
Recommended torque is 10 kgf·cm (9 lbf·in).
Be careful not to tip over the speaker.
4. Turn the speaker right side up.
5. Remove the protection cover.
SAFETY PRECAUTIONS:
• Attach the speaker bases in a manner that will not
allow the speakers to tip over.
• Be sure to tighten the screws when you attach the
speaker bases.
• Attach the speaker bases on a flat, level, and stable
floor.
• After you attach the speaker bases, make sure that the
speakers stand upright and are stable.
Attaching the Speaker Bases
Top of SKF-770
Protection cover
Supplied screws
Speaker base
Bottom of SKF-770
Arrow mark
HTP-770_EnFrEs.book Page 8 Wednesday, July 29, 2009 10:07 AM