Onkyo ED-205 - Manual (Page 10)

10 10
AV SURROUND PROCESSOR
STANDBY/ON
STANDBY
EFFECT MODE
MASTER VOLUME
MULTI CH INPUT LINE VIDEO-1/2
ED-205
POWER
OFF ON
AV SURROUND PROCESSOR
STANDBY/ON
STANDBY
EFFECT MODE
MASTER VOLUME
MULTI CH INPUT POWER LINE VIDEO-1/2
ED-205 OFF ON
If your system is totally configured with ONKYO separate
collection series components, you can use the system functions
using the ED-205's supplied remote controller.
Connect all components in series using the z cables, starting
with the amplifier. For components having two z REMOTE
CONTROL jacks, you may use either of them because their
functions are same.
• If your system already has been set up with the ONKYO
separate collection series components, connect the ED-205's
z REMOTE CONTROL jack to the CD player's or tuner's
unused z REMOTE CONTROL jack.
• To operate the system components, point the remote
controller toward the amplifier's remote control sensor.
• To operate the ED-205, point the remote controller toward the
ED-205's remote control sensor.
Notes:
• Do not use the z REMOTE CONTROL jack to connect
products not bearing the z symbol. Doing so may result in
the damage to the equipment.
• Connecting only the z cables is not sufficient for operation
of your system. Connect the components also via audio
connection cables.
• Connect the speaker cables before you connect the z cables.
Connecting the z cables
Connecting the power
Before plugging in the unit, confirm that all connections have
been made properly.
Turning on this unit’s power may cause a momentary power
surge, which might interfere with other electrical equipment,
such as computers. If so, use a wall outlet on a different circuit.
After plugging the ED-205’s power cord into an AC outlet, press
the POWER switch to put the unit in power-standby status (the
SATNDBY indicator is lit). The remote controller cannot be used
to operate the ED-205 if the POWER switch is not set ON.
When the POWER switch is set ON, pressing the STANDBY/
ON button or the POWER button on the remote controller
switches the ED-205 between standby status (the STANDBY
indicator is lit) and power on status (the display is lit).
Press the POWER switch on the ED-205 to set it to the OFF
position, turning of the unit.
STANDBY/ON button
POWER switch
ED-205
T-405R (Tuner)
A-909/A-909 LTD /A-905 (Amplifer)
MD-105 (MD Recorder)
C-705/C-705 LTD (CD Player)
STANDBY indicator