Omega Vehicle Security TJ-USB - Manual (Page 11)

Software 3
3-5
3.3 USB Driver Installation
To install the USB software drivers that are required for your TJ-USB probe to
operate correctly follow these procedures.
You need to have the User Software CD that was supplied with your probe loaded
into the CD drive on your PC.
1. Connect your TJ-USB probe to your computer. You should get a notice box
that indicates that your computer “Has Found New Hardware”
2. Your computer will then launch the Found New Hardware Wizard. Follow
the instructions indicated on the Wizard boxes and the additional
instructions noted in this manual with each box.
After completing the Found New Hardware Wizard your system will ask that you
repeat this process. This is normal. You should repeat the steps outlined here
twice. After the second driver is installed you should then get the “New Hardware
Ready For Use” notice.
Figure 9. Welcome To The Found New Hardware Wizard Screen
From this box you should check the “No, not at this time” button. Then click the
“Next >” button to continue with the driver installation process.
NOTE:
NOTE: