Audio setup page – OPPO Digital DV-987HD User Manual
Page 44
S E T U P M E N U O P T I O N S
40
Audio Setup Page
Digital Output
LPCM Rate
Audio Tone
Pro Logic II
Dolby Digital Setup
Channel Trim
Audio Delay
HDMI Audio
Raw
48KHz
00
05
LPCM
--- Audio Setup Page ---
1. Digital Output: To set the bit stream type of the digital audio output for use with Dolby Digital
and DTS-compatible receivers. The options are:
• Raw – Passes the encoded multi-channel digital audio unaltered. Choose this setting if
your receiver/amplifier is capable of decoding Dolby Digital and/or DTS.
• PCM – Forces down-mixed 2-channel digital audio output. Choose this setting if your
receiver/amplifier only supports stereo digital (PCM) audio.
2. LPCM Rate: To set the maximum Linear PCM output frequency. The options are:
• 48K – Supported by most equipment.
• 96K – Allows a higher sampling rate and frequency response. It can result better audio
quality. Ensure that the receiver/amplifier can support it.
• 192K – Allows the highest sampling rate and frequency response. It can result the best
audio quality. Ensure that the receiver/amplifier can support it.
Note:
The LPCM rate is selectable only when HDMI Audio is turned off.
3. Audio Tone (+/-16): This function raises or lowers the tone (key/pitch) of the audio track. This
is useful for playing Karaoke discs and should not be used for regular music listening or movies.
• Press
the
SELECT
button to show the tone control window.
• Press the left/right ARROW buttons to lower or raise the tone/pitch.
• Press
the
SELECT
button to confirm the setting.
4. Pro Logic II: Taking a step further than most DVD players, the OPPO DVD player allows you to
configure Dolby Pro Logic II to expand 2-channel source audio into full 5-channel surround
sound. Note: Pro Logic II functionality is effective only when Speaker Setup Page > Down-
mix
is set to “5.1ch” and Digital Output is set to “Raw”.
• Press
the
SELECT
button to enter the “Pro Logic II Config” page.
• Press the left ARROW button to exit the “Pro Logic II Config” page.
A. Pro Logic II: To turn on or off the Pro Logic II processing. The options are: