Olympus VP--1 - Manual (Page 18)

E-17
STATUS POWER STATUS POWER STATUS POWER
POWER
Finishing
Switch off the power of the connected equipment
Switch off the power of the projector
Main unit operation: Press and hold the POWER but-
ton for 1 second.
Remote control operation: Press the POWER OFF
button.
The "Power off" indication will appear.
When the red bar extends fully (in about 5 seconds), the
projection screen will go off and the unit will enter the
power off operation.
1
2
The POWER indicator changes to blinking
amber and lights a steady amber after about
90 seconds (when the unit enters the standby
mode).
Blinks amber
(Approximately
90 seconds) Lit amber
Standby mode
Unplug the power cable
Check that the sound of the cooling fan is quieter and that the POWER indicator is lit steadily in
amber, then unplug the power cable.
The POWER indicator will go off when the power cable is unplugged.
Power off
OK ?
Power off
OK ? ON OFF POWER
3
Warning
Do not disconnect the power cable while the POWER indicator is blinking in amber. Doing so
could shorten the life of the lamp or lead to breakdown of the projector.
Note
* The operation can be cancelled by pressing a button other than the POWER button.
* One more press of the POWER (POWER Off) button will switch off the power.