Onkyo TXNR1008 - Manual

1
Firmware Update for the TX-NR708/808/1008 & HT-RC270
The following outlines the methods to update the firmware via network and via USB storage. Please choose
either one that suits your condition. Before you start, carefully read the update procedure. It will take about 30
minutes to update the firmware.
*****IMPORTANT*****
THE A/V RECEIVER MUST BE IN USB MODE IN ORDER TO PREFORM THE UPDATE
Please see the procedure page(s) for details
Update via network You need a wired Internet connection to update the firmware. For the update
procedure, please refer to “Updating the Firmware via Network” (pg. 3).
Update via USB storage Please prepare a USB storage device such as a USB flash memory stick. You
need at least 32 MB of available space to update the firmware. For the update procedure, please refer to
“Updating the Firmware via USB” (pg. 6).
Precautions:
• Receiver MUST be in USB mode during updating process.
• Check the network connection before update.
• Do not touch the cable or any other device connected to the AV receiver during updating process.
• Do not access the AV receiver from PC during updating process.
• Do not shutdown the power of the AV receiver while update.
• The storage media in the USB card reader may not work.
• If the storage device has been partitioned, each section will be treated as an independent device.
• If the USB mass storage device contains a lot of data, the AV receiver may take a while to read it.
• Operation with all USB mass storage devices including the ability to power them is not guaranteed.
• Onkyo accepts no responsibility whatsoever for the loss or damage to data stored on a USB mass
• storage device when that device is used with the AV receiver. Onkyo recommends that you back up your important
music files beforehand.
• If you connect a USB hard disk drive to the USB port, Onkyo recommends that you use its AC adapter to power it.
•
USB hubs and USB devices with hub functions are not supported. Do not connect your USB mass storage device via
a USB hub.
• USB mass storage devices with security functions are not supported.
Limitation of liability
The program and accompanying online documentation are furnished to you for use at your own risk. Onkyo will not be
liable and you will have no remedy for damages for any claim of any kind whatsoever concerning your use of the
program or the accompanying online documentation, regardless of legal theory, and whether arising in tort or contract.
In no event will Onkyo be liable to you or any third party for any special, indirect, incidental, or consequential
damages of any kind, including, but not limited to, compensation, reimbursement or damages on account of the loss of
present or prospective profits, loss of data, or for any other reason whatsoever.