Oral-B Pulsonic Smart Series S 32.533.5 - Manual (Page 15)

15
Wall mount
If you prefer to mount the SmartGuide display
unit on a wall, mirror or other surface, use the
adhesive tape (k) to fix the wall mount (j). Before
doing so, make sure the chosen surface is clean
and dry (remove grease and dust first).
Position the wall mount so, that the Oral-B logo is
readable. Then, press the wall mount evenly and
firmly to the wall. Wait 24h before sliding the
SmartGuide display unit into the fixed wall mount.
Please note: The adhesive tape will not work on
dirt-repellent surfaces.
Cleaning recommendations
• After brushing, rinse your brush head
thoroughly under running water.
• Remove the brush head from the handle and
clean brush head and handle separately under
running water. Wipe them dry before you put
the handle back on the charging unit.
•
• From time to time you can also clean the
charging unit with a damp cloth. For thorough
cleaning you may remove the charger cover (h)
by pushing the release button on top of the
charging unit. The charger cover is dishwasher-
safe.
• Charging unit and SmartGuide display unit
should never be placed in water.
Synchronizing
To avoid interference of display messages
when using more than one Oral-B Pulsonic
SmartSeries toothbrushes with separate
SmartGuide display units in the same house-
hold, you need to assign the handles to their
respective SmartGuide display units.
To do so, please follow the steps below:
• Push the «h/min» button, located in the
SmartGuide battery compartment, for at least
3 seconds. The SmartGuide display unit
shows «L---», indicating the «Learn» mode
for synchronization is activated.
• Now you are requested by a flashing
on/off button in the toothbrush icon on the
SmartGuide display unit to turn the handle on.
When doing so, the automatic synchronization
process starts. It is finished when «L-1-» is
displayed.
•
• Then turn off the handle.
If you would like to assign a second handle to
the same SmartGuide display unit, repeat the
last two steps described above with the other
handle. You can exit the «Learn» mode by
pressing the «h/min» or «set» button. Otherwise
the «Learn» mode will automatically end after
30 seconds.
Please note:
• A maximum of 2 handles can be synchronized
with one SmartGuide display unit. After you
synchronized the second handle, «Full» will be
displayed.
• When changing batteries of the SmartGuide
display unit, stored data will be erased.
Therefore, please repeat the synchronization
process every time you change the batteries.
set h/min
3 sec.
96192337_S_32_WE.indd 15 28.01.13 08:48