Oregon MP810 - Manual (Page 9)

EN
6
NOTE: Windows 98SE-based computers indicate that new hardware
has been found and automatically installs the software drivers. If you
have not installed the software, please first install the program before
connecting the device.
TRANSFERRING FILES
After connecting your recorder to the computer, the computer will detect
and identify the device as a removable storage drive, allowing you to
drag and drop files between your computer and your player.
1. Select the voice or MP3 / WMA files from your computer.
2. Drag and drop the selected files into the Removable Disk.
NOTE: Your MP3 player is equipped for mass data storage support.
This means that it can also be used as a portable hard drive to store
and transport all forms of computer data files. You will not be able to
view or play any of the stored data unless it is one of the supported
audio formats.
• MP3 (Layer 3 MPEG-1, MPEG-2 and MPEG-2.5)
• WMA (Windows Media Audio)
• WAV (IMA ADPCM format)
NOTE: During file transfer, the audio player's LCD display shows a
symbol to signal PC-to-audio player connectivity. The LCD display
flashes
(writing file to player) or (writing file to computer)
to indicate that data is being transferred.
DISCONNECTING THE PLAYER FROM PC
Unplug your player when it displays . Do not unplug your player
during file transfer. Follow the procedures below to disconnect the
player from your computer running the following operating systems.
NOTE: Wrongly disconnecting or unplugging the player from
the PC during file transfer may damage the software and cause
your player to operate improperly. Please see the section on
"TROUBLESHOOTING" for more information.
MP810 Eng R5 a OP 10/5/04, 11:51 AM 6
¶´ƒ