Onkyo Power Amplifier M-5000R - Manual (Page 19)

19
En
This is an example of the bridge connection with the AV controller PR-SC5508.
Note
• When using the XLR inputs, do not connect anything to the RCA inputs. It may damage the power amplifier.
• Make sure that the XLR cable is not split. The split XLR cable may be the cause of noise.
• The power amplifier uses the European type XLR jack (pin 2 hot). If the AV controller/preamplifier with the USA type jack (pin 3 hot) is connected, the phase will be reversed. In this case, reverse the polarity of the speaker
connection.
• Set the INPUT SELECT switch to XLR side.
Bridge Connection
AV Controller PR-SC5508
Left Speaker
Power Amplifier M-5000R Power Amplifier M-5000R
Right Speaker