Oregon Scientific BMI Body Weight Monitor BWR102 - Manual (Page 5)

5
GB
TIPS
A. install the batteries to the unit.
B. when battery is first installed on both scale and remote display unit.
B-1. acquire weight on scale.
B-2. match the remote display unit with the scale.
Note:
a) beep sound to indicate the matching is activated.
b) check the reading on scale and remote display unit .
c) if fail, repeat step B-1 & B-2.
B-3. set the clock.
C. after changing batteries of the scale, repeat step B-1 & B-2.
D. after changing batteries of the remote display unit, set the clock only.
E. replace all batteries when appears on the scale.
F. replace battery when for scale or for remote display unit appears on remote display unit.
G. memory stored in remote display unit will not be ereased after changing batteries.
H. if there exist irregularity in weighing, press reset on the scale and then repeat step B-1 & B-2.
Note:
a) place a blunt stylus into the slot to press be reset.
b) after reset please wait for few seconds for the scale to self-calibrate.
I. allow the scale to settle for around 30 min if there is a sudden change in embient environment . eg. from
an air conditioned room to an open area.
If not disposed of properly, batteries can be harmful. Protect the environment by taking
exhausted batteries to authorized disposal stations.
To extend battery life, when battery power is low, replace all the batteries.