Oregon RGR682 - Manual (Page 6)

E
N
6
record, press SINCE. The date will appear on the
bottom line of the display.
To clear the existing commencing date and reset it to
start again, press and hold SINCE. The total rainfall
and today rainfall will be reset to zero and the unit will
start again to collect the rainfall data.
RAINFALL ALARM
The rain alarm value can be displayed at any time by
pressing RAIN .
To set the rainfall alarm:
1. Press and hold RAIN for two seconds.
2. Use HISTORY / UP or DOWN to set the desired
value.
3. Press RAIN to confirm. The alarm will be
activated.
The rain alarm indicator will light up.
The alarm will go off for one minute when the rainfall
reaches the preset value and the rain alarm indicator
will flash. A reminder beep will be emitted every minute.
Once the rain alarm is on the indicator will not stop
flashing unless RAIN
is pressed or the rain alarm
value is changed. To stop the alarm and reminder beep,
press any button or change the rainfall alarm value.
To toggle the alarm ON / OFF, press RAIN ON /
OFF.
SIGNALS
If without obvious reason the main unit display goes
blank, press and hold SEARCH for 2 seconds to
enforce an immediate search of the rain collector.
ICON DESCRIPTION
No signal
Searching for signal
Signal connected
If that fails, check:
•
The remote rain collector is still in place.
• The batteries of the main unit and rain collector have
not run out of power. Replace them if necessary.
• The transmission is within range and path is clear
of obstacles and interference. Shorten the distance
if necessary.
Then press SEARCH again.
CALENDAR CLOCK
The calendar clock is displayed on the bottom line
of the display. Use MODE to toggle between clock,
calendar and daily alarm.
To set the clock:
1. Press MODE to display the clock or calendar.
2. Press and hold MODE for two seconds and use
HISTORY / UP or DOWN to set the desired clock or
calendar value.
RGR682_M_EN_R1.indd 6 2006.8.2 10:18:53 AM