Onkyo TX-SR804 - Manual (Page 48)

48
Playing Your AV Components
Basic AV Receiver Operation
PUSH TO OPEN
STANDBY/ON
STANDBY
MASTER VOLUME
TAPE
ZONE 2
DISPLAY PURE AUDIO CD TUNER VIDEO 4 VIDEO 3 VIDEO 2 VIDEO 1 DVD MULTI CH PHONO
OFF ON
POWER
3
1
10 - - / - - - 11 12
REMOTE MODE
HDD RECEIVER
TAPE/AMP
DVD CD
ZONE2
SAT TV VCR CABLE
MD CDR
+
-
T V CH
T V VOL
ENTER
SET UP
TO P M ENU MEN U
VOL
+
-
CH
DISPLAY
PREV
CH
DIMMER SLEEP
MUTING
INPUT SELECTOR
3 2
MACRO
1
+10 0 CLEAR
1 2 3
4 5 6
7 8 9
INPUT I
ON STANDBY
T V
CD
V1 V2 V3
MULTI CH DVD
TUNER
PHONO
DISC
ALBUM
V4
TAPE
RE TURN
3
1
1
1 Use the AV receiver’s input selector buttons to select the input source.
To select the input source with the remote controller, press the
[RECEIVER] REMOTE MODE button, and then use the INPUT SELECTOR
buttons.
On the remote controller, the [V1], [V2], [V3], and [V4] buttons select the VIDEO 1,
VIDEO 2, VIDEO 3, and VIDEO 4 input sources respectively.
2 Start playback on the source component.
To watch a DVD or other video source, on your TV, select the video input that’s con-
nected to the AV receiver’s COMPONENT VIDEO OUT, HDMI OUT, or MONITOR
OUT.
On some DVD players, you may need to change the digital or HDMI audio output
settings.
3 To adjust the volume, use the MASTER VOLUME control or the remote
controller’s [VOL] button.
Since the AV receiver is designed for home theaters, it has a wide volume range for
precise adjustment. The volume can be set to –
∞ dB, –81 dB, –80 dB through +18 dB.
4 Select a listening mode and enjoy!
See “Using the Listening Modes” on page 60.
RECEIVER
DVD VIDEO 1 VIDEO 2
VIDEO 3 VIDEO 4 TAPE
TUNER CD PHONO
+10
1 2 3
4 5 6
7 8 9
CD
V1 V2 V3
MULTI CH DVD
TUNER
PHONO
V4
TAPE
Remote
controller
AV receiver
VOL
MASTER VOLUME
Remote
controller
AV receiver