MAXWELL MW-3014 B - Manual (Page 9)

9
ENGLISH
WATER SPRAYER
• You can dampen the fabric by pressing the
spray button (4) several times.
• Make sure that there is enough water in the
water tank (9).
IRONING
• Place the iron on its base (8).Insert the plug
into the socket.
• Turn the temperature control (10) to set the
required ironing temperature: “•”, “••”,
“•••” or max, (depending on the type of
fabric), set the constant steam supply con-
trol to the “ ” position, the (6) indicator will
light up.
• When the sole temperature reaches the de-
sired temperature value, the (6) indicator
will go out, you can start ironing.
• After you finish ironing set the control (10)
to the “min” position.
• Pull the plug out of the socket and let the
iron cool down completely.
STEAM IRONING
The iron is equipped with the anti drop valve,
which closes water supply at too low tem-
perature of the iron sole, it prevents appear-
ance of drops from the openings of the iron
sole (12). At heating and cooling down of the
iron sole you will hear corresponding clamps
of opening/closing of the anti-drop valve, that
indicates its normal operation.
• Place the iron on its base (8). (Place the
iron vertically.)
• Insert the plug into the socket.
• Make sure that there is enough water in the
water tank.
• Turn the temperature control (10) to set the
required ironing temperature: in the steam
operation zone or «max» (•••), the indica-
tor (6) will light up.
• When the sole temperature reaches the de-
sired temperature value, the (6) indicator
will go out, you can start ironing.
• Use the constant steam supply control (3)
set the required intensity of the vapor gen-
eration, steam will start going out of the
openings of the iron sole (12).
• After usage of the iron set temperature
control (10) to the “min” position, and the
constant steam supply control (3) to the “
” position (steam supply is off).
• Pull the plug out of the socket and let the
iron cool down completely.
ATTENTION!
If during the operation steam is not constantly
supplied, check whether the steam supply
control (3) is set properly and whether there
is water in the water tank.
STEAM SUPPLY
Steam supply function is useful while ironing
folds and can be used only at high tempera-
ture mode (temperature control (10) between
“••”, “•••”and “max”).
When pressing the steam supply button (5)
steam will go out from the sole.
Note:
- In order to avoid leakage of water from
steam openings, press the additional
steam supply button (5) with a 4-5 sec.
interval.
VERTICAL STEAMING
Vertical steaming function can be used only
when the high temperature mode is used (set
the temperature control (10) between «••»
and (max)).
Hold the iron vertically at the distance15-
30 cm from the clothes press the additional
steam release button (5) with a 4-5 seconds
interval, steam will be released from the sole
(12).
Important information
• Vertical steaming is not recommended for
synthetic fabrics.
• To avoid melting the fabric, do not touch
the iron sole to the item while steaming.
• Never steam iron clothing on a person as
the steam temperature is very high and it
can cause burns. Use a coat-hanger or a
stand.
STEAM CHAMBER CLEANING
• To prolong lifetime of the iron we recom-
mend cleaning the steam chamber, espe-
MW-3014.indd 9 MW-3014.indd 9 25.03.2011 17:45:07 25.03.2011 17:45:07