Onkyo A-1VL - Manual (Page 6)

6
Front & Rear Panels
1 POWER button
This button is used to set the A-1VL to On or Off.
2 POWER indicator
This indicator lights up when the A-1VL is ON.
While this indicator is illuminated, you can operate
the A-1VL with the remote controller.
3 MUTING indicator
This indicator lights up when the Muting function is
set.
4 VOLUME control
This control is used to set the volume of the A-1VL.
5 Remote control sensor
This sensor receives control signals from the remote
controller.
6 Input selector control
This control is used to select following input
sources: CD, LINE 1, LINE 2, TUNER and
PHONO.
7 DIRECT button
Turns on or off the DIRECT function. When you
use the A-1VL as a power amplifier, turn on the
DIRECT function.
1 PHONO
These analog inputs can be used to connect a
turntable with a moving-magnet cartridge.
2 TUNER
These inputs can be used to connect a tuner.
3 CD
These inputs can be used to connect a CD player
with analog outputs.
4 PREOUT
If you use the A-1VL as a preamp, these analog pre-
out can be connected to the inputs on a power amp.
5 MAIN IN
If you use the A-1VL as a power amp, these analog
inputs can be connected to the outputs on a separate
preamp.
6 SPEAKERS
These terminal posts are for connecting your speakers.
7 Grounding screw
This screw is for connecting a turntable’s ground wire.
8 LINE 1
These inputs can be used to connect a TV or other
component with analog outputs.
9 LINE 2 IN/OUT
These analog inputs can be used to connect a
cassette or MD recorder.
0 SPEAKER IMPEDANCE SELECTOR
This selector can be used to set the speaker imped-
ance values according to the speakers you use.
A AC INLET
The supplied power cord should be connected here.
Front Panel
Rear Panel