6 model 770 rear panel connectio, Model 200 connection diagram – Outlaw Audio 200 M-Block User Manual

Page 6

Advertising
background image

6

Outlaw Audio

Owner’s Manual

7

Model 200 M-Block Power Amplifier

Owner’s Manual

�������

���� �� �������� �����

�� ��� ����

��������

�� ������ ��� ���� �� ���� �� ��������

������ �� ��� ������ ���� ��������� �� ���� �� ��������

�������� ����� ��������� ��� �����

����� ������ �� ���� ������������� ��� �������

�������� ��� ��������� ���������� �������

���� ������� ������� ���� ���� ���� ���� ���� ����

���� ����

��� ����

������ ����

��� ����

������ �����

������� ������

������ ��� ����� ���������

�����

���� �������

�������

����

�����

��

���

��

���

������� �������

�����

�������

�����

��

���

���� ���� � ���� �����

����

����

��

��

������� ��

��� �������

���� �������

�� �����

������

������� ��

����� ������

�� ���

������

������

������� ���

������� ����

���� ���� ��

���� ������

�������� ��

����������

Model 200 Connection Diagram

Model 200 Connection Diagram

Cables with a gauge of 16 may be used for short runs of less than ten feet. We do
not recommend that you use any cables with an AWG equivalent of 18 or higher
due to the power loss and degradation in performance that will occur.
Cables that are run inside walls should have the appropriate markings in
indicate listing with UL, CSA or other testing agency standards. Questions
about cables inside walls should be referred to a qualified installer or a licensed
electrical contractor who is familiar with the NEC and/or the applicable local
building codes in your area.
If bare wire is used for the connections, strip approximately 1/2 inch to 3/4
inch (20mm) of insulation from the end of each wire and carefully twist the
strands of each conductor together. Be careful not to cut the individual strands
or twist them off; for optimal performance, all strands must be used.

Then, loosen the knobs of the speaker output terminals, far enough so that the
pass-through hole is revealed. Note that one conductor of the speaker cable will
have no markings, and the other will have a red line, brand name markings, a
black thread, or some other positive indication. Follow the proper connection
instructions for your system with regard to which terminals are used so that
proper system polarity is maintained by connecting the positive (usually red)
terminal on the speaker to the positive terminal on the Model 200 and the
negative (almost always black) terminal on the speaker to the black negative
terminal on the Model 200. After the connections are made, twist the cap back
so that the connection is secured, but do not over tighten or use tools, as this
may break the delicate wire strands and decrease system performance.

Advertising