Olympus C-2/D-230 - Manual (Page 12)

12 En
En
• When the memory gauge is full, no more images can be taken. Wait a few
seconds until the memory gauge goes off before taking any more pictures. See
“ The function of memory gauge” (
).
• Pleae use the close-up playback to check for details such as hand shake or
focusing. See “Close-up playback” ( p.21).
• It takes longer to record a picture when the monitor is used.
Caution
• Always press the shutter button gently. If you press too hard, the camera may
move and the image will be blurred.
• Never attempt to open the card cover or remove the AC adapter or batteries
while the orange lamp is blinking. Otherwise, the image you have just shot will
not be saved. Existing data on the SmartMedia card may also be destroyed.
• When alkaline batteries are used, the number of recordable images varies
widely depending on the brand and operation environment. Turn the monitor off
whenever you are not taking pictures, or when you are using the viewfinder to
compose your shot.
PLAYING BACK PICTURES
CHECKING RECORDED IMAGES (PLAYBACK)
You can play back images one by one on the monitor.
1 Press the button with the lens barrier closed.
The monitor turns on in the Play mode and shows the last picture you took.
(Single-image playback)
2 Press the / buttons.
Press the button to play back the previous image and the button to play
back the next image.
3 Press the button to stop playing back the image.
The monitor and the camera turn off.
Note When the camera turns on, the monitor may light for an instant and show an
image for a short time. This is not a malfunction.
ERASING AN IMAGE
1 Close the lens barrier and press the button.
The camera turns on in the Play mode.
2 Press the / buttons and play back the image you want to erase.
See “Checking recorded images” ( p.12).
3 Press the button for more than 1 second.
The monitor shows the single-image erase menu.
4 Select [ ERASE] using the / button and press the
button.
The selected image is erased.
1/Basic03_C2-E.65E 01.8.17, 10:04 AM 12