Oki 6120E - Manual (Page 81)

III - 33
Section 3 - Chapter 4 - Using the OkiLAN 6120e in NDPS
OKI OkiLAN 6120e User’s Guide
NetW
are
Chapter 4
Using the OkiLAN 6120e in NDPS
(NetWare 4.x , 5.1 or Higher)
Introduction
Novell â Distributed Print Servicesä (NDPS â ) is Novell’s new
printing architecture for use with NetWare versions 4.x, 5.1 and
higher. To use the OkiLAN 6120e in NDPS, you must add the OKI
printer driver(s) to the NDPS Broker.
Requirements:
·
IP Address on the file server
·
IP address on the print server (NetWare-only print servers will
not work)
·
The client must also run the most current version of the
NetWare client to get the NDPS objects.
Note: The client printing to the printer does not need an IP address.
Note: If you are using NetWare 5.1x or higher in TCP/IP, a quicker
setup procedure is described in Setting Up the OkiLAN 6120e in
NetWare 5.1x or Higher in TCP/IP below.
Adding the OKI Printer Driver Using the NDPS
Broker
Printer drivers cannot be installed to the Resource Management
Service from multiple floppy disks. If a printer driver is shipped on
more than one disk, copy the files to a directory on a hard drive or
network drive and install the driver from there. Any problems in
adding the driver should be addressed to the OKI Customer Service
Center.
1.
In NetWare Administrator, double-click the Broker object.
2. Click the Resource Management Service (RMS) tab.
3. Make sure the Resource Management Service is enabled.
4. Click Add Resources to display the Manage Resources
dialog box.
5. Select the icon for the type of printer driver that you want
to add under the Resource Types window.
A complete list of currently loaded printer drivers of that
type appears in the Current Resources window.