Oregon Scientific PS-L06U - Manual (Page 23)

EN
CONTINUOUS PROJECTION
The AC power adapter must be plugged in to use this
feature (
→ 8).
Press and hold SNOOZE/LIGHT for 2 seconds. when
the projection is on. When activated, the time and
alarm status will project continuously.
Press and hold SNOOZE/LIGHT for 2 seconds again
to deactivate.
RESET SYSTEM
The RESET buttons are located in the battery
compartments for the main and remote units. Press
these buttons with the tip of a blunt object (such as a
ball point pen) whenever you change the batteries, or
whenever performance is not behaving as expected
(e.g., unable to establish radio frequency link with
remote unit or automatic clock, etc.) This will return all
settings to default value, and you will lose all stored
information (minimum / maximum temperature and
humidity, preset stations, etc.).
SAFETY AND CARE
Wash the unit with a slightly damp cloth and mild
detergent. Avoid dropping the unit or placing it in a
location where the antenna or AC power adapter will be
stepped on.
21
PS-L06_GB-final.p65 8/8/03, 12:03 PM 23